The Digital Manufacturing Blog

We have encountered a lot of customers that have been more active over the past few years of converting existing metal parts to plastic parts...

We are often asked what options one has in SLA resolution. The answer is simple, normal resolution and high resolution. And deciding which..

When using cast urethane, it is important to ensure that your part is designed properly. If not, then the part may not mold properly, thus..

Urethane molding is used mainly for prototype, bridge, and lower volume production runs. The process by which urethane—or, polyurethane—molding..

Durometer describes the instrument used to measure hardness, as well as the material’s hardness. Durometer is measured by the depth of an..

Last week as National Small Business Week.  This is a time where the U.S. Small Business Administration (SBA) highlights the impact of small..

Last week, the Institute for Supply Management published its monthly ISM Manufacturing Report for April. The PMI was 51.5 percent, which is..

In recent years, the “reshoring” of jobs back to the U.S. has gathered momentum. Because of this, the current trend is overturning the loss of..

When printing Fuse Deposition Models (FDM) models, we can adjust the build density of the parts. This is very beneficial for you because the..

Regardless of your product, the cost of it is more than likely always on your mind. But have you ever determined how to reduce costs without..