Digital Manufacturing Blog | TTH

Kelly Lucha

One request we consistently hear is “How can you make my prototypes in color?” or “How realistic can you make my parts look?” Previously most..

This year, we are once again sponsoring the University of Akron’s SAE racing team. We work with their team to 3D print and manufacture various..

As the old saying goes, “It’s hard to teach an old dog new tricks”-Like converting metal parts to plastic.

We have encountered a lot of customers that have been more active over the past few years of converting existing metal parts to plastic parts...

We are often asked what options one has in SLA resolution. The answer is simple, normal resolution and high resolution. And deciding which..

When using cast urethane, it is important to ensure that your part is designed properly. If not, then the part may not mold properly, thus..

Urethane molding is used mainly for prototype, bridge, and lower volume production runs. The process by which urethane—or, polyurethane—molding..

Durometer describes the instrument used to measure hardness, as well as the material’s hardness. Durometer is measured by the depth of an..

Last week as National Small Business Week. This is a time where the U.S. Small Business Administration (SBA) highlights the impact of small..

Last week, the Institute for Supply Management published its monthly ISM Manufacturing Report for April. The PMI was 51.5 percent, which is..